PFAS in tap water, Belleville town/township, New Jersey

1 of 2 water systems had PFAS-4 above our 0.5 ng/L benchmark at the latest sample. Highest: Newark Water Department, 4.9 ng/L. 1 had PFOA or PFOS above the 4 ng/L federal MCL in at least one sample.

Belleville town/township is served by 2 community water systems · 329,403 people served

Water systems serving Belleville town/township

Water system People served PFAS-4 at the latest sample Entry points Latest sample
Newark Water Department 294,274 4.9 ng/L above the 2029 federal MCL 2 November 15, 2023
Belleville Water Dept 35,129 below the 3 to 4 ng/L reporting limit 1 May 21, 2024

Not sure which one is yours? The systems report their own service areas to EPA. Check your water bill or your utility's Consumer Confidence Report.

Census county subdivision "Belleville township", matched from the city rows the systems report to SDWIS.

County

How to read these numbers

We compare PFAS-4 (PFOA + PFOS + PFNA + PFHxS) with this site's 0.5 ng/L benchmark, the same line as on the European pages. UCMR 5 reporting limits are 3 to 4 ng/L. So any quantified PFAS-4 compound is above the benchmark, and a clean result reads "below the 3 to 4 ng/L reporting limit", never zero. The US legal limit is the 4 ng/L federal MCL for PFOA and PFOS, which systems must meet from April 26, 2029 ("above the 2029 federal MCL").

EPA: "UCMR 5 results do not indicate compliance or noncompliance with the PFAS drinking water standards". Samples are taken where water enters the distribution system, not at your tap. A system may have changed sources or added treatment since. Source: U.S. Environmental Protection Agency (EPA), Office of Water, PFAS National Primary Drinking Water Regulation (NPDWR). Regulation details retrieved September 19, 2026. Every system page tracks the 2029 compliance date and the proposed rescission of the PFHxS, PFNA, HFPO-DA and Hazard Index limits.

This site is a data project, not an official source. If in doubt, check with your water supplier or local authority.